Jiachengyue Intelligent Technology
Source strength manufacturer
Source strength manufacturer
On September 10, 2021, our company participated in the Automation equipment exhibition in Shenzhen International Convention and Exhibition Center. During the exhibition, people in the industry exchanged experience and learned from each other, introduced the equipment and demonstrated the operation o..
Date：2023-02-28
Problems to be understood before buying a tie machine: 1. Please take a picture of the product to confirm whether the product is suitable for the bin..
Date：2023-02-28
Pull material speed parameter set too fast, please slow down the speed to try to operate, pull spring is too loose will also lead to not tight enough, please tighten the spring, or pull material wheel clearance is too large, small wheel clearance can be adjusted.
Date：2023-02-28
Automatic nylon binding machine is widely used in wiring harness processing production line, bundling TV, computer and other electrical internal connection lines, lighting, motor, electronic toys and other products within the line fixed
Date：2023-02-28
Automatic nylon binding machine is widely used in electronics factory, binding TV, computer and other internal connection lines, using automatic PLC touch screen control circuit, easy to operate, good working stability. Automatic nylon binding machine is the key to improve production efficiency, so ..
Date：2023-02-28
Cable tie, as the name suggests, is a strap to tie things up. Cable tie is also called cable tie, cable tie, binding tape binding tape. The design of the cable tie has a stopping function, which can only be tightened, but there are also detachable cable ties. The most commonly used cable ties can be..
Date：2023-02-28
Nylon cable ties are a kind of binding stuff, it replaces the traditional rope, is a development of modern technology. Let's take a look at the transportation and storage secrets of nylon cable ties.
Date：2023-02-28
If it is worn, please replace the drawing wheel. Cutter wear will also lead to this situation. If it is cutter wear, it also needs to replace the new cutter, or it is because the CAM of the drawing wheel has high friction force.
Date：2023-02-28
Please open the cover and see the elastic screws on both sides of the pulling wheel. Loosen the roms first and tighten the screws after adjusting the pulling wheel to the appropriate distance.
Date：2023-02-28
If the parameters are incorrectly adjusted, please restore the parameters retained before delivery, or contact the technician of the manufacturer directly, or replace the cable ties with the previous ones because the cable ties are deformed. Check the cable ties to ensure the quality of the cable ti..
Date：2023-02-28
The reason is that there is dirt in the vibration disk, the vibration disk is set slowly, and there is too much material in the vibration disk. It is necessary to clean the vibration disk and reset the speed, and part of the material is taken out.
Date：2023-02-28
Please check whether the vibration disk is properly connected to the machine interface. After the connection is properly connected, tighten the four small fixing screws of the vibration disk to ensure that the vibration disk is full of materials before it starts to work. Nylon cable ties more burr o..
Date：2023-02-28
189-2252-0163
